你好!
这是NOS BUNDLE!
来自同一时代的所有基于Tube的插件。
包括TUBA,TuPre和Kolin。
TUBA
具有2频段均衡器的电子管麦克风/线路放大器。
基于著名的电子管控制台。 DIY版本的原始硬件与国防部。
特征
– LEVEL:输入驱动器。完全补偿以避免增益变化。
–增益:输入驱动增益范围。
– MIC / LINE:可选择的麦克风前置放大器或线路放大器,用于不同的字符和颜色。
– LF:低频,具有大约100 Hz的宽搁板。
– HF:高频,具有大约8 kHz的宽搁板。
– 0/180:相位开关
– PAD:20 dB的衰减,而不会影响增益水平。它将增加净空。
–输出:清洁输出
– ANALOG OBSESSION:此标签是可单击的。它将变成红色并进行过采样(4x)
可用格式
VST / VST3 / AU | Mac 10.9 – 11.X
VST / VST3 | Windows 7 – 8 – 10
更新–版本2.0 – 25.3.2021
–完全优化的电路和改进的DSP
–为每个频段增加了独立的旁路
–降低CPU使用率
–增加了4倍过采样
–增加了读数
–重新设计的“眼睛轻松” GUI
TuPRE
带有自定义无源程序均衡器的电子管放大器。多彩而坚实的设计为您服务!
不模拟任何齿轮。完全定制设计。简单但对任何来源都非常有效。
特征
–增益:45 dB线路放大器(增益补偿)
– LOW:100Hz架子,+ /-10dB
–高:10kHz架子,+ /-10dB
–输出:清洁输出
– ANALOG OBSESSION:此标签是可单击的。它将变成红色并进行过采样(4x)
可用格式
VST / VST3 / AU | Mac 10.9 – 11.X
VST / VST3 | Windows 7 – 8 – 10
更新–版本2.0 – 25.3.2021
–完全优化的电路和改进的DSP
–为每个频段增加了独立的旁路
–降低CPU使用率
–增加了4倍过采样
–增加了读数
–重新设计的“眼睛轻松” GUI
科林
老式限幅放大器具有其他功能,例如可调节的起音和释放。
特征
– A-ADJUST:1ms至50ms的启动时间
– R-ADJUST释放时间为0.1秒至3秒
– MIX:混合DRY和WET信号的旋钮
– HPF:20Hz至500Hz侧链
– EXT-SC:外部侧链
– INPUT LEVEL:40dB增益补偿输入控制
–输出电平:+/- 20dB输出控制
– ANALOG OBSESSION:此标签是可单击的。它将变成红色并进行过采样(4x)
可用格式
VST / VST3 / AU | Mac 10.9 – 11.X
VST / VST3 | Windows 7 – 8 – 10
更新–版本4.0 – 25.3.2021
–完全优化的电路和改进的DSP
–为每个频段增加了独立的旁路
–降低CPU使用率
–增加了4倍过采样
–增加了读数
–重新设计的“眼睛轻松” GUI
Hi!
Here is NOS BUNDLE!
All tube based plugins from same era.
Included TUBA, TuPre and Kolin.
TUBA
Tube mic/line amp with 2 band EQ.
Based on famous tube console. DIY version of original hardware with mods.
Features
– LEVEL: Input drive. Fully compensated to avoid gain changes.
– GAIN: Input drive gain range.
– MIC/LINE : Selectable mic preamp or line amp for different characters and colors.
– LF: Low frequency with broad shelf around 100 Hz.
– HF: High frequency with broad shelf around 8 kHz.
– 0/180: Phase switch
– PAD: 20 dB pad without affecting gain level. It will increase headroom.
– OUTPUT: Clean output
– ANALOG OBSESSION: This label is clickable. It will turn to red and engage Oversampling (4x)
Available Formats
VST/VST3/AU | Mac 10.9 – 11.X
VST/VST3 | Windows 7 – 8 – 10
UPDATE – VERSION 2.0 – 25.3.2021
– Fully optimized circuit and improved DSP
– Added independent bypass for each band
– Lower CPU usage
– Added 4x Oversampling
– Added readout
– Redesigned “easy on eyes” GUI
TuPRE
It’s tube line amp with custom passive program equalizer. Colorful and solid design for you!
Not emulating any gear. Fully custom design. Simple but really effective for any source.
Features
– GAIN: 45 dB line amp (Gain Compensated)
– LOW: 100Hz shelf with +/- 10dB
– HIGH: 10kHz shelf with +/- 10dB
– OUTPUT: Clean output
– ANALOG OBSESSION: This label is clickable. It will turn to red and engage Oversampling (4x)
Available Formats
VST/VST3/AU | Mac 10.9 – 11.X
VST/VST3 | Windows 7 – 8 – 10
UPDATE – VERSION 2.0 – 25.3.2021
– Fully optimized circuit and improved DSP
– Added independent bypass for each band
– Lower CPU usage
– Added 4x Oversampling
– Added readout
– Redesigned “easy on eyes” GUI
Kolin
Vintage limiting amplifier with additional features like adjustable attack and release.
Features
– A-ADJUST: 1ms to 50ms Attack Time
– R-ADJUST 0.1sec to 3sec Release Time
– MIX: Knob to blend DRY and WET signal
– HPF: 20Hz to 500Hz Sidechain
– EXT-SC: External Sidechain
– INPUT LEVEL: 40dB gain compensated input control
– OUTPUT LEVEL: +/- 20dB output control
– ANALOG OBSESSION: This label is clickable. It will turn to red and engage Oversampling (4x)
Available Formats
VST/VST3/AU | Mac 10.9 – 11.X
VST/VST3 | Windows 7 – 8 – 10
UPDATE – VERSION 4.0 – 25.3.2021
– Fully optimized circuit and improved DSP
– Added independent bypass for each band
– Lower CPU usage
– Added 4x Oversampling
– Added readout
– Redesigned “easy on eyes” GUI